input errors on cisco router

[MarkoAnastasov45813]

Hello guys!

I hope that all of you are well and safe in this crazy time.

Is it this errors  problem or not and how to fix it

Thank you in advance.

FastEthernet0/0 is up, line protocol is up
Hardware is AmdFE, address is 000e.837a.8f80 (bia 000e.837a.8f80)
Internet address is 192.168.0.49/24
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:02, output 00:00:02, output hang never
Last clearing of "show interface" counters 01:21:22
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
7813 packets input, 10090576 bytes
Received 812 broadcasts, 0 runts, 0 giants, 0 throttles
15 input errors, 0 CRC, 0 frame, 7 overrun, 8 ignored
0 watchdog
0 input packets with dribble condition detected
2857 packets output, 278195 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out

[Mark Elsen · Accepted solution]

 - Check if this thread can help you :

           https://community.cisco.com/t5/small-business-routers/interface-input-errors/td-p/2964643

  M.

[MarkoAnastasov45813]

Thank you!

[Leo Laohoo · Accepted solution]

---

@MarkoAnastasov45813 wrote:

Full-duplex, 100Mb/s, 100BaseTX/FX

---

Post the complete output to the command "sh run int f 0/0". 

It looks like the speed and duplex are hard-coded.  IF this is the case, then the line errors are due to auto-negotiation (or lack of).

[MarkoAnastasov45813]

Thank you!