cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1373
Views
0
Helpful
2
Replies

install and removing line card in WS-C6506

xine xine
Level 1
Level 1

Hi

I'm have to install and removing module in our old C6506 switch chassis.  Actually CatOs is running on these system

here show version output command

WS-C6506 Software, Version NmpSW: 5.5(19)
Copyright (c) 1995-2003 by Cisco Systems
NMP S/W compiled on Mar 27 2003, 17:17:17

System Bootstrap Version: 5.3(2)

Hardware Version: 2.0  Model: WS-C6506  Serial #: ******************

Mod Port Model               Serial #    Versions
--- ---- ------------------- ----------- --------------------------------------
1   2    WS-X6K-SUP1A-2GE   ********************  Hw : 3.7
                                         Fw : 5.3(2)
                                         Fw1: 5.4(2)
                                         Sw : 5.5(19)
                                         Sw1: 5.5(19)
         WS-F6K-PFC          ************* vHw : 1.1
2   8    WS-X6408A-GBIC      ***************** Hw : 1.3
                                         Fw : 5.4(2)
                                         Sw : 5.5(19)
3   48   WS-X6348-RJ-45      ******************* Hw : 2.2
                                         Fw : 5.4(2)
                                         Sw : 5.5(19)
4   8    WS-X6408A-GBIC      ************* Hw : 3.1
                                         Fw : 5.4(2)
                                         Sw : 5.5(19)
15  1    WS-F6K-MSFC2        ************** Hw : 2.5
                                         Fw : 12.1(19)E1
                                         Sw : 12.1(19)E1

I like to know if I have to run command before or after removing module and command running before/after installing module.

excepting saving configuration of the device in case of failure... and running sh tech command output to having information of the state of the switch before module change activity.

I find equivalent document to which I'm looking for but this document is written for switch running IOS :

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a008086ed2e.shtml

Someone having equivalent for CatOs switches ?

Thanks

2 Replies 2

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

Just follow the same document you provided in the link.  Make sure to save, backup the config and the card is comparable with your sup and slot.  Also make sure you have an outage window when you do this incase some thing goes wrong.

Good Luck

Reza

smogra
Cisco Employee
Cisco Employee

Hi,

You can use the same document which you pointed out in your query. The same document explains for both IOS and Catos boxes. Just follow the document checklist and steps:

  • Verify if the module is supported by the supervisor engine of the destination switch.

  • Verify if the module is supported by the release of OS (IOS or CatOS) that runs on the destination switch.

  • Verify if the module can be placed in the choosen slot on the destination switch.

Hope that helps.

Cheers

Sweta

P.S. Please rate the answer if it helped.