04-09-2017 11:17 PM - edited 03-08-2019 10:08 AM
Why i am getting below error while booting cisco 3850 switch .can you please explain some one explain briefly .
Also please provide the solution
04-09-2017 11:31 PM
can you add the configuration for this switch? and is anything physically attached to the link and should the link be up?
Please rate if useful
04-10-2017 01:23 AM
Hi,
I configured the switch , But now inter vlan routing not working.
Can you please confirm because of this this is happening
Thanks,
04-10-2017 02:23 AM
tsjujith,
sorry but its impossible to say without the config.
also, share with us what you are trying to ping (IP addresses)
Please rate if useful
04-10-2017 10:33 AM
Hello!
I found this post, maybe it can help you with your problem: https://supportforums.cisco.com/discussion/11919461/cisco-3850-crash-startup
---Do not forget to rate useful answers--
Regards,
02-11-2018 10:22 PM
I am getting this command interface ge 0 link down***error phy link is down in cisc0 3650 switch.
when this command show in this console then no log came to the console.
switch status system and active going to amber mode. what the hp-pend ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: