12-04-2007 03:01 AM - edited 03-05-2019 07:48 PM
Hi all!
I have 3560g with EMI. I connect my PC to GEth0/3 3560g and create SVI with address x.x.x.209 255.255.255.240, on my PC address is x.x.x.210 255.255.255.240. I add Linksys SRW224G4 to GEth0/2 port 3560g. I have trunk between 3560g and Linksys. Linksys has management vlan 553 and 10.0.77.70/27 address in this vlan. I create SVI (vlan 553) on 3560g with address 10.0.77.65 255.255.255.224. Linksys has default-gateway 10.0.77.65.
3560G:
...
!
ip routing
...
!
interface Vlan201
ip address x.x.x.209 255.255.255.240
...
!
interface Vlan553
ip address 10.0.77.65 255.255.255.224
#sh ip route | i 10.0.77
C 10.0.77.64/27 is directly connected, Vlan553
#sh ip route | i x.x.x
x.x.x.0/28 is subnetted, 1 subnets
C x.x.x.208 is directly connected, Vlan201
I can ping 10.0.77.65 from my PC and I can ping x.x.x.209 from Linksys, but I can't ping 10.0.77.70 (Linksys) from my PC and I can't ping x.x.x.210 (PC) from Linksys.
I enable debug ip icmp packet, when I ping Linksys from PC or I ping PC from Linksys I'm not see anything. When I ping 10.0.77.65 from PC I see rows with echo requests and echo replies. I see is similar for Linksys.
What is problem may be?
12-07-2007 07:38 AM
Great !
12-07-2007 11:24 PM
yes, thanks.
I'm disturb because I want using linksys with trunk to catalyst..
12-08-2007 10:10 AM
Why would you need a trunk if you are only carrying a single Vlan over this link ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide