06-20-2011 11:08 AM - edited 03-07-2019 12:54 AM
I just recenetly bought a used ws-c3750g-48-ps-s. I noticed the switch would not boot but there is a file on the flash. It is not a .bin file but it is a .tar file. I guess I am just wondering if anyone knows the procedure on how to get this file onto my tftp server so I can extract it (I'm guessing the .bin IOS file will be there once I am able to extract this .tar file)
06-20-2011 11:35 AM
copy flash:
06-20-2011 11:49 AM
It says "Tftp: no such device"
I guess i am not sure how to setup my tftp on this switch in this mode. My TFTP server is 192.168.50.109 if that helps at all.
06-20-2011 11:54 AM
Are you in ROMMON?
06-20-2011 12:16 PM
Yeah I am in rommon. I just bought this switch used and thats how it came. I mean I could look into downloading it but I am curious how this .tar file even got on here and wanted to try and learn how to do this.
06-20-2011 12:18 PM
a .tar file is an old unix archive mechanisim.
there is some free ware to un-tar it
http://www.peazip.org/tar-windows.html
thats just one. you can poke around.
06-20-2011 12:28 PM
I basically want to get it off this switch so I can un-zip it and then I will copy over the IOS at that point, assuming it extracts an IOS .bin file
06-20-2011 12:05 PM
Is there any reason you chose not to just download the *.bin file of your IOS image from Cisco.com's support page?
06-20-2011 01:16 PM
Check out this thread, it should get you going.
http://forums.whirlpool.net.au/archive/888839
Hope it helps.
06-20-2011 03:58 PM
The problem is that I do not have this file on my computer, it's only on the switch. I cannot get the file off the switch and onto a PC to extract the neccesary files. It looks like this is a lost cause/no way of getting a .tar file onto my PC. Too bad, would have been fun to figure out.
06-20-2011 02:34 PM
Ok so if your switch is in ROMmon and you've got a TAR file then there's other way to boot that but use the ROMmon method.
Recovery From Corrupt or Missing Software Image on Cisco Catalyst 2900XL and 3500XL Series Switches
If you want to unpack the TAR file you can use WinRAR.
12-09-2022 07:09 AM
the owner may have have copied a tar file to the flash instead of extracting it. when installing IOS from .tar you extract using the archive command and not using the copy command like when you are installing from the bin file. you will have to delete the .tar file and install a fresh IOS
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide