06-07-2021 09:46 AM
Hello Community,
I'd like to know if there is a command that can show local ports that are connected on a switch for a given VLAN.
I mean for example I have Vlan 10 mapped to an IP range, and 5 interfaces configured as access vlan10, there is a command that can show thoses interfaces with IPs given in the range mapped to VLAN10?
Thanks in advance for your support.
Regards.
06-07-2021 11:11 AM
There is no such command, I guess you could use the following commands:
1.- sh vlan brief - use this one to map the interfaces configured on vlan 10
2.- sh mac address-table - use this command to verify the mac address seen on such interfaces
3.- sh ip arp - find the entry in the ARP table using the mac addresses found with the previous command, compare and you'll find the IP address.
HTH
06-07-2021 01:33 PM
based on DHCP pool set up for Vlan 10 range, and those 3 commands listed by isbou1986 you should be able to get your answer.
what is purpose of this? maybe we can help other way?
Regards, ML
**Please Rate All Helpful Responses **
06-08-2021 01:46 AM
Hello,
Thank you for your replies, I'm going to see if with above command I can find what I'm looking for.
Thanks again.
Regards.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide