Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community,I have to configure two IPSec tunnels on a cisco 4221 router, each tunnel should be established with a different router but the two tunnels should work in active/standby mode, how can I do this please?Topology is as below.
Hello,Need help for below please.Below is the kind of topology I have, and I want to connect behind L2VPN network. with the configuration I did, I can see traffic in on the physical interface(0/0/0/1) connected to the L2VPN network but no traffic out...
Hello Dears,I have one VSS in my network and I wanted to connect them with two routers via VRRP link, but I when I finished configurations it seems that I have loop on the VSS because it starts bugging the cPU usage increase higher. Below is my confi...
Hello Community,I'd like to know if there is a command that can show local ports that are connected on a switch for a given VLAN.I mean for example I have Vlan 10 mapped to an IP range, and 5 interfaces configured as access vlan10, there is a command...
Hello,I'm new in this forum, and I've been searching a solution for my issue I did not find any, so I decided to post my own and hope that someone can help me to solve the issue.As per the subject, I have inserted one A9K-MPA-4X10GE in my router whic...
@Rob Ingram Hi, I don't have any configuration, they are new routers, but what is important here is the configuration on R1, because R2 and R3 belong to another organization with whom I should make secure connexion. I should have two VPN on R1 that w...
