IP Nat Command missing

[w4waqas]

I have cisco3850 L2/L3 Switch , when i try enabling Nat on it, the IP NAT Command not found detail of hardware mentioned below

Model Revision Number : T0
Motherboard Revision Number : A0
Model Number : WS-C3850-48U
System Serial Number : FOC1919U11G

Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 56 WS-C3850-48U 16.3.5b CAT3K_CAA-UNIVERSALK9 INSTALL

[MHM Cisco World]

This SW not support any NAT

Sorry 

MHM

[Martin L]

Simply NAT is not supported on any Cisco switches since the beginning; it is not likely cisco change in the future but never say never....

Regards, ML
**Please Rate All Helpful Responses **  

[MHM Cisco World]

Friend new cat 9000 series support NAT

MHM