ip policy route-map command on 3750

[jtlampe0316]

I am trying to set up a route-map on a 3750 I have as a collapsed core-distribution. The route-map can be configured but when I try to put the "ip policy route-map name" command on the vlan interface it does not apply the command. I am running the 12.2(40)SE6 IOS on the switch. Any thoughts?

[Jon Marshall]

James

2 things to check -

1) are you running IP services/Advanced service (eg. not IP Base). You need to be.

2) if you are running the right feature set have you enabled the SDM routing template.

Jon

[jtlampe0316]

I do have the ipservices version of the IOS running (advipservice not available for switches) and I did enable the SDM routing template. The switch accepts the command but on "show run" the command is not displayed as being implemented.

[Jon Marshall]

Have you tested it ie. does it actually policy route ?

[ganyehcuan]

Hi All,

I am facing the same problem when applying the ip policy-route-map ... at the vlan interface and when show run it doesn't appear. Have configured the "sdm prefer routing" as per advised but still no luck. Below is the software version and switch model for your advise.

System image files is "flash:/c3750e-universalk9-mz.122-58.SE2

License Level: ipservices

Model number: WS-C3750X-24T-S

[ganyehcuan]

Hi All,

Now I managed to apply the ip policy route-map at the vlan interface and it is showing and even when I input the show ip policy and it is showing the interface which is the vlan that associated with the said route-map. But it is still not working.... need help!

[Antonio Knox]

Silly question, but did you enable routing?

conf t

ip routing

end

May not be your issue, but this problem wreaks of easy solution, we often overlook the small things.  Happens to me sometimes.

Hope that helps.

[jsfsantos]

I solve this problem with the command "sdm prefer routing". After I put this command and reload the switch. The command ip policy router-map accept the apply in the interface vlan configuration.

Thanks For Help.

[Jon Marshall]

James

Can you just confirm you are apply this to a L3 vlan interface eg.

int vlan 10

ip policy-route-map ....

Jon

[jtlampe0316]

I am applying it to the vlan interface but it isn't showing up in the running configs.

[jsfsantos]

Hi, i'm with the same problem. When I applied the command in the switch its works without error, but I check the command in the int vlan and the command is not applied. I use the software version 12.2(35)SE5 - C3750-IPSERVICES-M (Stack Switch). Did you find a solution to this problem. I think that its a bug of the sofware.

Regards,

João Ferreira.

[Thotsaphon Lueangwattanaphong]

Hi Guys,

    Please post the output of "show sdm prefer".  If it's "default desktop" , Please try the following command.

!

Switch(config)#sdm prefer routing

Switch#wr

Switch#reload

!

HTH,

Toshi

[Stu Erskine]

thanks all,

this was SOOOO helpful.

Stu

CCNP-Security

[tonyhaikool@gmail.com]

Hi member.

i have a problem on switch 3750G.a configuration PBR on switch but not command line "ip policy route-map ...

i type command sdm prefer

SW_01(config)#ip ?
Global IP configuration subcommands:
access-list Named access-list
accounting-list Select hosts for which IP accounting information is
kept
accounting-threshold Sets the maximum number of accounting entries
accounting-transits Sets the maximum number of transit entries
address-pool Specify default IP address pooling mechanism
admission Network Admission Control (NAC)
alias Alias an IP address to a TCP port
arp IP ARP global configuration
arp IP Arp features
auth-proxy Authentication Proxy
cef Cisco Express Forwarding
classless Follow classless routing forwarding rules
default-gateway Specify default gateway (if not routing IP)
default-network Flags networks as candidates for default routes
device Device tracking
dhcp Configure DHCP server and relay parameters
dhcp-client Configure parameters for DHCP client operation
dhcp-server Specify address of DHCP server to use
domain IP DNS Resolver
domain-list Domain name to complete unqualified host names.
domain-lookup Enable IP Domain Name System hostname translation
domain-name Define the default domain name
finger finger server
forward-protocol Controls forwarding of physical and directed IP
broadcasts
ftp FTP configuration commands
gdp Router discovery mechanism
gratuitous-arps Generate gratuitous ARPs for PPP/SLIP peer addresses
host Add an entry to the ip hostname table
host-routing Enable host-based routing (proxy ARP and redirect)
hp-host Enable the HP proxy probe service
http HTTP server configuration
icmp ICMP options
igmp IGMP global configuration
kerberos KERBEROS configuration commands
local Specify local options
mroute Configure static multicast routes
msdp MSDP global commands
multicast Global IP Multicast Commands
multicast-routing Enable IP multicast forwarding
name-server Specify address of name server to use
options IP Options treatment
ospf OSPF
pim PIM global commands
port-map Port to application mapping (PAM) configuration
commands
prefix-list Build a prefix list
radius RADIUS configuration commands
rcmd Rcmd commands
reflexive-list Reflexive access list
route Establish static routes
routing Enable IP routing
sap Global IP Multicast SAP Commands
scp Scp commands
security Specify system wide security information
sla IP Service Level Agreement
snap Commands affecting SNAP-encapsulated frames
source IP source
source-route Process packets with source routing header options
ssh Configure ssh options
sticky-arp Allow the creation of sticky ARP entries
subnet-zero Allow 'subnet zero' subnets
tacacs TACACS configuration commands
tcp Global TCP parameters
telnet Specify telnet options
tftp tftp configuration commands
verify URPF config commands

SW_01(config)#end
SW_01#show sd
SW_01#show sdm pre
SW_01#show sdm prefer
The current template is "desktop routing" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.

number of unicast mac addresses: 3K
number of IPv4 IGMP groups + multicast routes: 1K
number of IPv4 unicast routes: 11K
number of directly-connected IPv4 hosts: 3K
number of indirect IPv4 routes: 8K
number of IPv4 policy based routing aces: 0.5K
number of IPv4/MAC qos aces: 0.5K
number of IPv4/MAC security aces: 1K

SW_01#show ver
SW_01#show version
Cisco IOS Software, C3750 Software (C3750-IPBASEK9-M), Version 12.2(55)SE9, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2014 by Cisco Systems, Inc.
Compiled Mon 03-Mar-14 22:44 by prod_rel_team
Image text-base: 0x01000000, data-base: 0x02D00000

ROM: Bootstrap program is C3750 boot loader
BOOTLDR: C3750 Boot Loader (C3750-HBOOT-M) Version 12.2(44)SE5, RELEASE SOFTWARE (fc1)

SW_01 uptime is 1 day, 4 hours, 28 minutes
System returned to ROM by power-on
System image file is "flash:/c3750-ipbasek9-mz.122-55.SE9.bin"

This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to
export@cisco.com.

cisco WS-C3750G-48TS (PowerPC405) processor (revision F0) with 131072K bytes of memory.
Processor board ID FOC1146Z4PQ
Last reset from power-on
14 Virtual Ethernet interfaces
104 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.

512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 00:1E:49:A1:D5:00
Motherboard assembly number : 73-10218-08
Power supply part number : 341-0107-01
Motherboard serial number : FOC11455RX6
Power supply serial number : AZS114319EF
Model revision number : F0
Motherboard revision number : C0
Model number : WS-C3750G-48TS-S
System serial number : FOC1146Z4PQ
Top Assembly Part Number : 800-26857-02
Top Assembly Revision Number : A0
Version ID : V04
CLEI Code Number : COM7X10ARA
Hardware Board Revision Number : 0x09

Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 52 WS-C3750G-48TS 12.2(55)SE9 C3750-IPBASEK9-M
2 52 WS-C3750G-48TS 12.2(55)SE9 C3750-IPBASEK9-M

Switch 02
---------
Switch Uptime : 1 day, 4 hours, 28 minutes
Base ethernet MAC Address : 00:1E:BD:95:DB:00
Motherboard assembly number : 73-10218-08
Power supply part number : 341-0107-01
Motherboard serial number : FOC11493DLT
Power supply serial number : AZS1146256X
Model revision number : F0
Motherboard revision number : C0
Model number : WS-C3750G-48TS-S
System serial number : FOC1149Y4BQ
Top assembly part number : 800-26857-02
Top assembly revision number : A0
Version ID : V04
CLEI Code Number : COM7X10ARA

Configuration register is 0xF

SW_01#

help me!!!!!