cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
8002
Views
0
Helpful
4
Replies

IP SLA Reachability Issue - Up/Down

GRANT3779
Spotlight
Spotlight

Hi All,

I have the following configured and ever since applying it my logs were filling up with messages (also below). Is something amiss in the config causing this or my timer/threshold the issue? From my investigations I don't think the remote IP is ever becoming unreachable and is always up.

track 1 ip sla 1 reachability
ip sla 1
 icmp-echo 192.168.168.50
 threshold 300
 timeout 300
 frequency 1

 

001460: Aug 26 2015 12:37:25.817: %TRACKING-5-STATE: 1 ip sla 1 reachability Down->Up
001461: Aug 26 2015 13:00:59.178: %TRACKING-5-STATE: 1 ip sla 1 reachability Up->Down
001462: Aug 26 2015 13:01:04.185: %TRACKING-5-STATE: 1 ip sla 1 reachability Down->Up
001463: Aug 26 2015 13:09:25.343: %TRACKING-5-STATE: 1 ip sla 1 reachability Up->Down
001464: Aug 26 2015 13:09:30.351: %TRACKING-5-STATE: 1 ip sla 1 reachability Down->Up
001465: Aug 26 2015 13:55:16.923: %TRACKING-5-STATE: 1 ip sla 1 reachability Up->Down
001466: Aug 26 2015 13:55:21.931: %TRACKING-5-STATE: 1 ip sla 1 reachability Down->Up
001467: Aug 26 2015 13:55:31.947: %TRACKING-5-STATE: 1 ip sla 1 reachability Up->Down
001468: Aug 26 2015 13:55:36.954: %TRACKING-5-STATE: 1 ip sla 1 reachability Down->Up

 

 

4 Replies 4

John Blakley
VIP Alumni
VIP Alumni

Looking at your events, it looks like they work fine for a while. Is the egress point that you use to get to this address getting saturated at all? If so, you may think about using a qos policy to prefer the icmp packets sourced from this router....

 

HTH,

John

HTH, John *** Please rate all useful posts ***

Hi John,

Thinking of the design and traffic flow of this setup you may well be onto something there....will look into this in morning and keep you posted.

Cheers

Hello

Try increasing the timeout and frequecny values to see if that helps?

Also are you using this sla with HRSP ?

res

Paul


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

James Qin
Level 1
Level 1

Under:- track 1 ip sla 1 reachability

Configure:- delay down 5

Sometime the probe gets lost due to bad link or random discard from QoS.

This config will make your router hold for 5 second before considering the host is unreachable.

Change 5 seconds to something suitable to your requirement.

 

 

Please mark as useful if this helps you.

Review Cisco Networking for a $25 gift card