03-27-2017 08:39 AM - edited 03-08-2019 09:56 AM
Hi everybody,
i use "iperf3" to see the speed of a switch (not only made by Cisco), putting 2 pc to both the side of the switch.
Is there a way to see also the total used bandwidth of a switch, in a specific time?
My goal is to see if a switch's bandwidth is satured or if there is a particular port which is using it a lot.
Many thanks.
03-27-2017 12:33 PM
Hi,
Is there a way to see also the total used bandwidth of a switch, in a specific time?
Not sure about specific time, but you get the average switch percentage utilization by using this command:
sh controllers utilization
HTH
03-28-2017 02:23 AM
"sh controllers utilization" shows all zeroes!
03-28-2017 07:23 AM
This is the only command I found with this explanation:
"Switch Bandwidth Utilization"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide