cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
494
Views
0
Helpful
2
Replies
Highlighted
Beginner

IPSLA feature on - Nexus9000 C9396PX

Hi.. I have been running nexus 9396PX-n9000-dk9.6.1.2.I3.4a.bin. I want to configure IPSLA and track on this device but unable to configure it.

Does this device support IPSLA.

CoreSW(config)# feature ?
  bash-shell             Enable/Disable bash-shell
  bfd                    Bfd
  bgp                    Enable/Disable Border Gateway Protocol (BGP)
  dhcp                   Enable/Disable DHCP Manager
  eigrp                  Enable/Disable Enhanced Interior Gateway Routing Protocol (EIGRP)
  evmed                  Enable/Disable Generic event detectors
  hsrp                   Enable/Disable Hot Standby Router Protocol (HSRP)
  interface-vlan         Enable/Disable interface vlan
  isis                   Enable/Disable IS-IS Unicast Routing Protocol (IS-IS)
  lacp                   Enable/Disable LACP
  ldap                   Enable/Disable ldap
  lldp                   Enable/Disable LLDP
  msdp                   Enable/Disable Multicast Source Discovery Protocol (MSDP)
  ntp                    Enable/Disable NTP
  nv                     Enable/Disable VxLAN
  nxapi                  Enable/Disable nxapi
  ospf                   Enable/Disable Open Shortest Path First Protocol (OSPF)
  ospfv3                 Enable/Disable Open Shortest Path First Version 3 Protocol (OSPFv3)
  password               Credential(s) for the user(s)/device(s)
  pbr                    Enable/Disable Policy Based Routing(PBR)
  pim                    Enable/Disable Protocol Independent Multicast (PIM)
  private-vlan           Enable/Disable private-vlan
  privilege              Enable/Disable IOS type privilege level support
  rip                    Enable/Disable Routing Information Protocol (RIP)
  scheduler              Enable/Disable scheduler
  scp-server             Enable/Disable SCP server
  sftp-server            Enable/Disable SFTP server
  ssh                    Enable/Disable ssh
  tacacs+                Enable/Disable tacacs+
  telnet                 Enable/Disable telnet
  tunnel                 Enable/Disable Tunnel Manager
  udld                   Enable/Disable UDLD
  vmtracker              Enable/Disable VM Tracker feature
  vn-segment-vlan-based  Enable/Disable VLAN based VN segment
  vpc                    Enable/Disable VPC (Virtual Port Channel)
  vrrp                   Enable/Disable Virtual Router Redundancy Protocol (VRRP)
  vtp                    Enable/Disable VTP

===========================================================================

CoreSW(config)# ip ?
  access-list        Configure access list
  adjacency          Configure Adjmgr
  adjmgr             AM information
  arp                Configure ARP parameters
  as-path            BGP autonomous system path filter
  auto-discard       Auto 0.0.0.0/0 discard route
  community-list     Add a community list entry
  dhcp               Configure DHCP snooping or relay
  dns                Configure dns client
  domain-list        Add additional domain names
  domain-lookup      Enable/Disable DNS
  domain-name        Specify default domain name
  extcommunity-list  Add a extcommunity list entry
  ftp                Configure FTP client
  host               Add an entry to the ip hostname table
  http               Configure HTTP client
  icmp-errors        ICMP unreachable/TTL-exceeded/param-prob messages
  igmp               IGMP global configuration commands
  internal           Show internal information
  load-sharing       ECMP load-sharing
  mfwd               Configures Global IP Multicast Forwarding
  mroute             Configure multicast RPF static route
  multicast          Configure IP multicast global parameters
  name-server        Specify nameserver address
  prefix-list        Build a prefix list
  radius             Radius server
  route              Route information
  routing            Routing information
  source             Configure source-address for applications
  source-route       IP source routing option
  tcp                Global TCP parameters
  telnet             Configure telnet
  tftp               Configure TFTP client
  traceroute         Configure traceroute client

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

Its is supported from v7 as below should be feature sla available are on v6

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/7-x/ip_sla/configuration/guide/b_Cisco_Nexus_9000_Series_NX-OS_IP_SLAs_Configuration_Guide_7x/b_Cisco_Nexus_9000_Series_NX-OS_IP_SLAs_Configuration_Guide_7x_chapter_010.html 

This chapter provides release-specific information for each new and changed feature in the Cisco Nexus 9000 Series NX-OS IP SLAs Configuration Guide.

New and Changed Information

This table summarizes the new and changed features for the Cisco Nexus 9000 Series NX-OS IP SLAs Configuration Guide and where they are documented.

Table 1 New and Changed Features

Feature

Description

Changed in Release

Where Documented

IP SLA support

Initial support

7.0(3)I2(1)

View solution in original post

2 REPLIES 2
Highlighted
VIP Mentor

Its is supported from v7 as below should be feature sla available are on v6

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/7-x/ip_sla/configuration/guide/b_Cisco_Nexus_9000_Series_NX-OS_IP_SLAs_Configuration_Guide_7x/b_Cisco_Nexus_9000_Series_NX-OS_IP_SLAs_Configuration_Guide_7x_chapter_010.html 

This chapter provides release-specific information for each new and changed feature in the Cisco Nexus 9000 Series NX-OS IP SLAs Configuration Guide.

New and Changed Information

This table summarizes the new and changed features for the Cisco Nexus 9000 Series NX-OS IP SLAs Configuration Guide and where they are documented.

Table 1 New and Changed Features

Feature

Description

Changed in Release

Where Documented

IP SLA support

Initial support

7.0(3)I2(1)

View solution in original post

Highlighted

Hi, I have version  NXOS: version 7.0(3)I7(1) and the feature is not there yet!

 

Software
BIOS: version 07.59
NXOS: version 7.0(3)I7(1)
BIOS compile time: 08/26/2016
NXOS image file is: bootflash:///nxos.7.0.3.I7.1.bin
NXOS compile time: 8/31/2017 14:00:00 [08/31/2017 18:29:32]


Hardware
cisco Nexus9000 C9236C chassis
Intel(R) Xeon(R) CPU @ 1.80GHz with 16400580 kB of memory.

 

is there something that I need to activate?

 

thanks,

Marc

Content for Community-Ad