05-20-2011 02:24 AM - edited 03-06-2019 05:09 PM
Hello everyone !
I'm trying to set up a small network with one cisco 3750G. I've got 3 VLANs, two for client subnets and one for my windows 2008 r2 dhcp server. I want to use my windows server as the dedicated dhcp server. I have assign ipv6 addresses to all my vlans and tried to enable ipv6, ipv6 unicast-routing and relay agents but i can't get any leases from my dhcp server to my clients. Has anyone got a clue on how to solve this ?
//MrJanolov, Sweden
Solved! Go to Solution.
05-20-2011 02:45 AM
Hi,
You want your clients to get ipv6 config via DHCP and not the addresses via SLAAC? if so then you can suppress RA on the interface pointing towards client with the ipv6 nd suppress-ra command or use the ipv6 nd managed-config command to tell the clients to use DHCPv6 and not SLAAC.
Regards.
Alain.
05-20-2011 02:45 AM
Hi,
You want your clients to get ipv6 config via DHCP and not the addresses via SLAAC? if so then you can suppress RA on the interface pointing towards client with the ipv6 nd suppress-ra command or use the ipv6 nd managed-config command to tell the clients to use DHCPv6 and not SLAAC.
Regards.
Alain.
05-20-2011 04:02 AM
yes exactly.Okey I'll try to supress the RA, will be back with the results. Thnx for your answer.
//MrJanolov
05-20-2011 06:22 AM
Hello again!
It worked when I added both commands under the client VLANs. Thnx again.
//MrJanolov
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide