10-06-2013 02:10 AM - edited 03-07-2019 03:51 PM
Hi,
I have surprised to see the default MTU size 9216 on cisco 6509 e Series switch, but when i check the interface it is showing 1500 Bytes MTU. Also i cant even see for which module or interface the MTU size 9216 is enabled.
I am trying yo speedup our server farm as i am facing very low speed issue.
please help.
regards,
Azeem
10-06-2013 04:31 AM
Hi Azeem,
you have to set the MTU per port:
!
int gi1/1
mtu 9126
!
cheers,
Seb.
10-06-2013 04:56 AM
hey Seb,
tried that one already it gives... the below result. Please go through the output below
Switch(config-if)#mtu ?
% Unrecognized command
My IOS ver:- Version 12.2(18)SXF17b
Supervisor Engine 720 WS-SUP720-BASE
Switch(config)#system jumbomtu ?
<1500-9216> Jumbo mtu size in Bytes, default is 9216
Switch(config)#do sh int g2/25
GigabitEthernet2/25 is up, line protocol is up (connected)
Hardware is C6k 1000Mb 802.3, address is 0015.f9f1.7ae8 (bia 0015.f9f1.7ae8)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
Regards,
Azeem
10-06-2013 07:04 AM
Hi,
What type of line card do you have?
The WS-X6548-GE-TX, WS-X6548V-GE-TX, WS-X6148-GE-TX, and WS-X6148V-GE-TX do not support jumbo frames.
more info here:
HTH
10-07-2013 04:24 AM
Dear Reza,
I will check and confirm
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide