05-25-2018 11:18 AM - edited 03-08-2019 03:08 PM
Hello Guys,
I configure Aruba 2930F with Intervlan routing and configure ip routing, setup static route :
ip routing
vlan 1 : ip address 10.10.31.65 255.255.255.0
vlan 50: ip address 10.110.50.1 255.255.255.0
Vlan 51 : ip address 10.110.51.1 255.255.255.0
ip route 0.0.0.0 0.0.0.0 10.10.1.1 (router interface)
then on router i configure one port with IP 10.10.1.1 255.255.255.0 , no shutdown.
Then i configure static routes on router, ip route 10.110.50.0 255.255.255.0 10.10.31.65
ip route 10.110.51.0 255.255.255.0 10.10.31.65
I can not ping Router ip from switch and switch from router. ?
I am confuse the port that connected from switch to router should be trunk configured or access ?
05-25-2018 12:39 PM
Your route on Aruba:
ip route 0.0.0.0 0.0.0.0 10.10.1.1 (router interface)
is invalid as there is no presence of 10.10.1.x network on Aruba. Aruba can't reach 10.10.1.1 so it can't use this static route.
HTH.
05-29-2018 06:43 AM
Hello rais,
I change my router address to 10.10.31.75 and 10.10.31.0 is the default vlan on Aruba switch, Now i can ping my router from Aruba and vice-versa.
But when on access layer switch, I connect PC, It cannot ping router ?
I already have static route- ip route 0.0.0.0 0.0.0.0 10.10.31.75
05-29-2018 02:04 PM
Do you have a vlan1 interface on switch with address 10.10.31.x?
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: