ā03-08-2021 09:57 AM
Hello,
Hope you are doing well,
I did a project with your help, that consist of 6 companies with 6 different Vlans with 3 L3 switches. So when I am sending a packet from Vlan to another, the packet cant reach the other switch.
My doctor told me to enable "ip routing" on the switches, but I can't find the command lines to put them on CLI of the switches.
If anyone can help me that would be great.
Regards,
Elias.
ā03-08-2021 10:06 AM
Hello
Can you confirm the make/model of switches you are working on?
post the output of:
Show version
ā03-08-2021 01:52 PM
Hello,
is this a 'real' network, or a simulated (e.g. Packet Tracer) network ? Post the full configurations of all three layer 3 switches, as well as a diagram of your topology, so we can see what is connected to what.
ā03-08-2021 11:14 PM
ā03-09-2021 03:44 PM - edited ā03-09-2021 03:48 PM
command to enable the ip routing is ip routing. to check ip routing is ON or Off, show ip route command
login into switch, type enable at > prompt, enter config t or conf t, (short for configure term), type ip routing.
Regards, ML
**Please Rate All Helpful Responses **
ā03-08-2021 05:40 PM
you wrote packet cant reach the other switch, so you do not need ip routing at all. this will happen on L2 type of switches,. note that ip routing command only works on L3 switches and if you use Packet tracer, not all L3 switches will take that ip routing commend or ip routing is on by default.
Regards, ML
**Please Rate All Helpful Responses **
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide