cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
200
Views
0
Helpful
2
Replies
groupedlsi
Beginner

LACP across two 2960s

Hello, does anybody know if I can setup a cross-stack LACP between two stacked C2960S-48TS-L(with the additional stack module) ?

If it is, is there any limit (ports or groups limits)?

Thanks a lot,

Ludovic

2 ACCEPTED SOLUTIONS

Accepted Solutions
glen.grant
Advisor

  You should be able to do that .  On older 2960's they were limited  to  6 port channels per box , don't know if that has changed on the newer 2960's or not.

View solution in original post

Ankur Arora
Beginner

Hi

Cross Stack LACP is possible.

However you still have there is a limitation to 6 port-channels.

Please go through the following link for details:

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_25_see/configuration/guide/swethchl.html#wp1275881

Thanks

Ankur

"Please rate if found useful"

View solution in original post

2 REPLIES 2
glen.grant
Advisor

  You should be able to do that .  On older 2960's they were limited  to  6 port channels per box , don't know if that has changed on the newer 2960's or not.

View solution in original post

Ankur Arora
Beginner

Hi

Cross Stack LACP is possible.

However you still have there is a limitation to 6 port-channels.

Please go through the following link for details:

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_25_see/configuration/guide/swethchl.html#wp1275881

Thanks

Ankur

"Please rate if found useful"

View solution in original post