06-13-2012 04:42 PM - edited 03-07-2019 07:14 AM
In Cisco Catalyst switches, Is LACP doable between 1Gb and 10Gb ports. In other words if I want to configure LACP between two Cisco switches. Can I take (2) 1Gb and (2) 10Gb ports from each switch and configure LACP?
Solved! Go to Solution.
06-13-2012 05:51 PM
EtherChannel technology is not dependent on any type of media. it can be used with Ethernet running on copper wiring, or single-mode and multimode fiber, no problem.
plz Rate if it helped.
Soroush
06-13-2012 05:00 PM
Hi,
No, you can not pair mismatch speeds in one bundle. etherchannel is doable between different speeds from 10Mbps to 10Gbps, but all the links in a bundle must be of a same speed and duplex configuration.
you can read more here:
http://www.cisco.com/en/US/tech/tk389/tk213/technologies_white_paper09186a0080092944.shtml
plz Rate if it helped.
Soroush.
06-13-2012 05:47 PM
Hello
06-13-2012 05:51 PM
EtherChannel technology is not dependent on any type of media. it can be used with Ethernet running on copper wiring, or single-mode and multimode fiber, no problem.
plz Rate if it helped.
Soroush
04-07-2020 12:40 AM
Njein. depending on the hardware config, the 10G ports will fallback to 1G and thus create a 2x1G LACP.
If the hardware is fixed 10G, then the other comment comes into place, LACP needs same duplex/speed settings on both and all ends.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide