Hello admins.
I have been struggeling with a network setup for some time now and i think i've gotten close to getting it done (thanks to help from many of you guys)
however i'm currently stuck on a new hurdle.
In the topology above i've decided to cut off every 02 device (for now) to get a setup running with just the firewall, L3 switch and L2.
currently i cannot go from the inside network to the outside.
the firewall can ping 8.8.8.8 but nothing from the inside can.
we have a client setup on the layer 2 switch, that client can ping 192.168.1.1 (L3 switch interface pointing towards the FW) and 192.168.1.2 (FW interface pointing towards L3) but if 8.8.8.8 or our public gateway is tracerouted it goes to 192.168.2.2 (Vlan 2 on L3) and then get's dropped from there.
Can anyone help me out with figuring out what needs to be done.
very much appriciated.
