Link aggregation possible with 892FSP?

[SilentHunter124]

Hi *,

I have a little question. Is it possible to take two Gigabit Switch-Ports of a 892FSP Router and aggregate these with a non cisco switch?

[lauresfrank]

Hi!

unfortunately not. I have the same issue. You can create Port-Channels itself, but command is not available under interface commands.

I dont know why they they disabled it, it is just a software limititation I guess.

C892-(config-if)#int port-channel 10
C892-(config-if)#exit

C892-(config)#int gigabitEthernet 1
C892-(config-if)#channel-group ?
% Unrecognized command