Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi *,
I have a little theoretical question. I own some internal Servers which are currently opened to the internet with an ACL and over NAT Ports. Normally this is not a problem, as the servers are secured by strong authentication mechanisms.
But...
Hi everybody,I have a little problem understanding this article: http://www.cisco.com/c/en/us/support/docs/routers/10000-series-routers/50421-config-register-use.htmlIf I want, the Router, to boot the IOS from for example tftp://192.168.0.1/NAME.xyz...
Hi *,I have a little stupid problem with my easy VPN Server. I took the following configuration to configure the VPN: ClickI can successfully ping 192.168.99.1 but when I start AnyConnect (enter this IP-Address as serveraddress) on my IPhone, it firs...
Hi *,I've a little problem with my 890SFP Router, which is configured behind a Virtual DMZ.The 192.168.178.0/24 network is the DMZ and the 192.168.0.0/24 is my network with all my devices.The router has NAT and the inside interface is 192.168.0.1, th...
In other words, this function is not intended for my use case, correct? My intent is to protect an Exchange Server ActiveSync and OWA by an additional System which requests Certificate Based Authentication (CBA). Most Active Sync Clients are capable ...
Obviously there are two different ways doing this.Via Config reg and netboot (default filenames)And this howto: https://supportforums.cisco.com/blog/150396/booting-cisco-router-tftp-server
You mean beyond my Gi0/8 interface (which is also nat inside) I should add ip nat inside on interface Virtual-Template3 type tunnel? Okey I will do so.But I searched my config for the pat pool and can't find any pat pool. The only pools I have is a d...
Okey I used the Cisco Configuration Professional and created a new Loopback Interface and Easy VPN Server.Now it works. I can connect to the VPN Server via IPhone and can access the internal IP Addresses.BUT:How do I configure a next Hop-address for ...
