Hi All,
I'm investigating a bit of an outage we had on our Netgate based Ipsec VPN which I think is almost certainly related to the netgate. But looking on our core switch stack which is a pair of SG350XG's, I note in the system log a lot of entries like this;
2147447075 2021-Jan-11 17:17:34 Informational %LINK-I-Up: te1/0/1
2147447076 2021-Jan-11 17:07:09 Warning %LINK-W-Down: te1/0/1
2147447077 2021-Jan-11 17:07:09 Informational %LINK-I-Up: te1/0/1
2147447078 2021-Jan-11 16:57:41 Warning %LINK-W-Down: te1/0/1
2147447079 2021-Jan-11 16:57:41 Informational %LINK-I-Up: te1/0/1
2147447080 2021-Jan-11 16:50:12 Warning %LINK-W-Down: te1/0/1
2147447081 2021-Jan-11 16:50:12 Informational %LINK-
2147447082 2021-Jan-11 16:41:27 Warning %LINK-W-Down: te1/0/1
2147447083 2021-Jan-11 16:41:27 Warning %TRUNK-W-PORTREMOVED: Port te1/0/1 removed from Po3
2147447084 2021-Jan-11 16:41:13 Informational %TRUNK-I-PORTADDED: Port te1/0/1 added to Po3
2147447085 2021-Jan-11 16:41:10 Informational %LINK-I-Up: te1/0/1
2147447086 2021-Jan-11 16:40:27 Warning %LINK-W-Down: te1/0/1
2147447087 2021-Jan-11 16:40:27 Warning %TRUNK-W-PORTREMOVED: Port te1/0/1 removed from Po3
2147447088 2021-Jan-11 13:34:29 Informational %TRUNK-I-PORTADDED: Port te1/0/1 added to Po3
2147447089 2021-Jan-11 13:34:26 Informational %LINK-I-Up: te1/0/1
2147447090 2021-Jan-11 13:21:10 Warning %LINK-W-Down: te1/0/1
2147447091 2021-Jan-11 13:21:10 Warning %TRUNK-W-PORTREMOVED: Port te1/0/1 removed from Po3
Port 1 is an uplink to our Edge stack I have two (one on each of the core switches) connected via Port Channel.
Is it normal for this sort of thing to happen or do I need to check cabling or make some config change ?
thanks in advance for any help.
Paul.
