12-10-2012 10:45 PM - edited 03-07-2019 10:31 AM
in my organization i want to load balance duel WAN link also want to ensure Fail over with IP SLA. can you give some idea how it can be down. what i did better i will explain firstly ........
i did load balancing with PBR and its working fine. for example there are two VLAN in my organization .First 1. VLan 10 & 2nd is Vlan 20 . I want Vlan 10 goes in ISP 1 and VLAN 20 goes in ISP 2 & its working fine . but the prbolem is when i want to configure IPSLA for fail over then its create problem like i want to, if ISP 1 is down VLAN 10 data will go on ISP 2 , But if ISP 2 is down then vlan 20 does not go on ISP 1 . Can any one give some idea......how it can be done .......
Solved! Go to Solution.
12-11-2012 01:36 AM
Hi,
For such thing you need to track object with IP SLA both ISPs. And match to PBRs.
Refer to this example https://supportforums.cisco.com/docs/DOC-8313
Hope it will help.
12-10-2012 11:09 PM
Hi,
Can you post your config.
Regards.
Alain
Don't forget to rate helpful posts.
12-10-2012 11:14 PM
ip route 0.0.0.0 0.0.0.0 x.x.x.x
ip route 0.0.0.0 0.0.0.0 x.x.x.x 10
route-map Duel-Link-route permit 1
match ip address 20
set ip default next-hop ISP 1 Peer IP
route-map Duel-Link-route permit 1
match ip address 30
set ip default next-hop ISP 2 Peer IP
this is PBR configuration with i did in My router , BUT can you explain how i can implement IPSLA with this senario
12-11-2012 01:36 AM
Hi,
For such thing you need to track object with IP SLA both ISPs. And match to PBRs.
Refer to this example https://supportforums.cisco.com/docs/DOC-8313
Hope it will help.
12-11-2012 02:47 AM
can you send us ISP connectivity topology? does ISP connected directly on CORE or Router?
may below page help you -
12-11-2012 04:25 AM
thanks to all but can you give me idea 2821 router which Image capable for configure IP SLA , bcz my 2821 router image is
"flash:c2800nm-ipbase-mz.150-1.M3.bin" , where is no feature of IPSLA configuration.
12-11-2012 04:25 AM
thanks to all but can you give me idea 2821 router which Image capable for configure IP SLA , bcz my 2821 router image is
"flash:c2800nm-ipbase-mz.150-1.M3.bin" , where is no feature of IPSLA configuration.
12-11-2012 05:38 AM
Hi,
you need 15.1(2)T , take a look here to which are available images:http://tools.cisco.com/ITDIT/CFN/jsp/by-feature-technology.jsp
Regards.
Alain
Don't forget to rate helpful posts.
12-12-2012 11:20 PM
Thanks Abzal , Nice explanation documment ......
09-12-2018 09:05 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: