09-06-2017 06:36 PM - edited 03-08-2019 11:56 AM
Hi Guys,
Just configuring up a 9k running - NXOS: version 7.0(3)I6(1)
and struck this;
i was looking to configure:
switch# configure terminal switch(config)# login block-for 100 attempts 3 within 60 switch(config)# show login
as per;
any ideas?
Solved! Go to Solution.
09-06-2017 11:35 PM
Hi Warren,
It seems like the documentation is not fully up to date. Starting with 7.0(3)I6(1), the commands have been renamed to system login block-for and system login quiet-mode; the corresponding show commands are show system login and show system login failures.
I will file a documentation defect for this to have the configuration guide updated.
Best regards,
Peter
09-06-2017 11:35 PM
Hi Warren,
It seems like the documentation is not fully up to date. Starting with 7.0(3)I6(1), the commands have been renamed to system login block-for and system login quiet-mode; the corresponding show commands are show system login and show system login failures.
I will file a documentation defect for this to have the configuration guide updated.
Best regards,
Peter
09-07-2017 12:13 AM
Warren and all,
I've filed the documentation defect CSCvf86915 for this - it should be publicly accessible within a day or two at:
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvf86915
Best regards,
Peter
05-10-2018 12:28 AM
Starting with 7.0(3)I6(1), the "login block-for" and "login quiet-mode" mode commands are no longer available in the configuration mode; instead, they have been replaced with "system login block-for" and "system login quiet-mode", respectively:
switch(config)# login ?
on-failure Set options for failed login attempt
on-success Set options for successful login attempt
switch(config)# system login ?
block-for Set quiet-mode active time period
quiet-mode Set quiet-mode options
Also, the "show login" command has been updated; the related commands are "show system login" and "show system login failures":
switch# show login ?
on-failure Authentication failure
on-successful Authentication successful
switch# show system login ?
<CR>
> Redirect it to a file
>> Redirect it to a file in append mode
failures Display Login failures in the current watch period
| Pipe command output to filter
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide