cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1235
Views
15
Helpful
4
Replies

Low privilege account creation

vipinrajrc
Level 3
Level 3

Hi Experts,

I need to create a low privilege account, just to view only show commands. I already have created a full privilege account (local username) and binded with the telnet line. also enable password is there.

I tried by creating a enable password with level1  priviliege.

please provide a suitable suggestion.

Thanks

Vipin

Thanks and Regards, Vipin
4 Replies 4

Hi Vipin,

See the below example configs.

#username six privilege 6 password 0 six

privilege exec level 6 show running


As per above config user six is able to Telnet in and execute the show run command, but the resulting configuration is virtually blank because this user cannot configure anything (configure terminal is at level 8, not at level 6). The user is not permitted to see usernames and passwords of the other users, or to see Simple Network Management Protocol (SNMP) information.


Please rate the helpful posts.
Regards,
Naidu.

Hi,

I just need to create privilege level with the following commands

show running-config

sh ip int brief

sh cdp neighbors

ping

traceroute

sh interface

sh ip route

I tried with the level6, but from show run there is nothing .

Is there any special meaning to the levels? Why you specify level 6?? Why not level 5 or level 7?????

That is my doubt... is there any special meaning for different levels????

Thanks

Vipin

Thanks and Regards, Vipin

Dear Vipin,

Creating "views" is a good option..

http://www.fir3net.com/Router/Cisco-Router/creating-cli-views-on-a-cisco-router.html

Thank you

Naren

Review Cisco Networking for a $25 gift card