05-20-2014 02:58 AM - edited 03-07-2019 07:28 PM
Hi,
I have 2 PCs (1gbps lan card each ) connected to Cisco 2960-S switch.
The bandwidth of all ports on 2960-S is set to 1gbps manually.
However whenever I transfer any file between the two I don't get transfer rate more than 12MBps/96mbps.
Theoretically it should be 125MBps but why am I getting such low transfer rate?
Regards.
05-20-2014 04:07 AM
Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
Bandwidth is set manually, eh? Have you checked for a duplex mixmatch?
05-20-2014 06:08 AM
Hi,
Under every interface on switch we have set full duplex and 1gbps bandwith manually.
Ex, int gi1/0/1
duplex full
bandwidth 1000000 (in kbps)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide