cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5466
Views
0
Helpful
2
Replies

<deleted>

Dennis Goh
Level 1
Level 1
2 Replies 2

Reza Sharifi
Hall of Fame
Hall of Fame

Dennis,

Can you change the Cisco side to LACP passive and Juniper to active?

also, can you post your Juniper config?

Reza

SunilKhanna
Level 1
Level 1

Dennis,

With LACP configuration and Error: pagp_switch_is_in_port_channel: , I see this as a transient issue. Try reloading the switch.

Pls vote if you think the post was helpful.

Regards,

Sunil

Regards, Sunil Khanna
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card