Hello I am seeing a strange issue on the MAC address table
Attached is the drawing of the setup
When I do a show mac address table for a particular MAC which is the MAC address of the WLC I see all the VLANs being shown but not the one for 900. any advice as to why this could be the case?
sh mac address-table | include 9064
2 c08c.60c7.9064 DYNAMIC Fa1/0/19
1 c08c.60c7.9064 DYNAMIC Fa1/0/19
3 c08c.60c7.9064 DYNAMIC Fa1/0/19
800 c08c.60c7.9064 DYNAMIC Fa1/0/21
VLAN 1 is the Management but I think I should have been able to see the VLAN 900 in this mac address table as well?
Anything I need to check for this?
thanks in advance.