10-27-2015 12:11 PM - edited 03-08-2019 02:27 AM
Hello All
I am seeing a issue and would be grateful to have any assistance regarding this.
My setup is as follows:
Router --> Core SW --> LAN Switch
I am trying to gain access to the SH using AUX port --
Router config is
interface GigabitEthernet0/0.25
description ### SH AUX ###
encapsulation dot1Q 25
ip address 172.28.184.211 255.255.255.254
ip flow ingress
ip flow egress
end
LAN Switch config is as follows:
interface GigabitEthernet3/0/48
description SH_AUX
switchport access vlan 25
switchport mode access
power inline never
speed 100
duplex full
no mdix auto
spanning-tree portfast
end
But i cannot ping the the AUX port which is 172.28.184.210; Mask is 255.255.255.254.
I cannot see the mac address on the mac address table on the switch
The VLANs are allowed on both the switch, have anyone seen this issue before and know how i can fix it please?
10-27-2015 12:25 PM
Hi,
The router's port is configured as trunk and switch port is configured as access port. They both need to be the same type. So you can simply change the switch side to be trunk.
switchport mode trunk
and test
HTH
10-27-2015 12:52 PM
Thanks Reza for your reply.
But if we consider a workstation connected to the port it should always be an access port right? even though the router is configured as encapsulation?
10-27-2015 01:07 PM
That is correct. Workstation to the switch is an access port. I was under the impression that you are connecting the switch to the router with the config you posted.
How is the lan switch is connected to the core and core to the router? If the switches are layer-2 only, than you want trunk port from the lan switch to the core and from the core to the router.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide