cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2567
Views
3
Helpful
26
Replies

mac flapping

Apr 16 04:14:35.390: %SW_MATM-4-MACFLAP_NOTIF: Host 001b.0907.fe0e in vlan 11 is flapping between port Gi1/1/1 and port Gi1/1/2Apr 16 04:14:35.390: %SW_MATM-4-MACFLAP_NOTIF: Host 001b.0907.fe0e in vlan 11 is flapping between port Gi1/1/1 and port Gi1/1/2

26 Replies 26

And the vlan12 bpdu is sent only not recieve.

So these three SW not recieve root SW bpdu and it elect new Root SW this mac flapping and make your SW not stable.

Now check SW connect to these three SW (wrong root bridge and I am sure it these three SW connect to each other in chain) if SW connect to these SW recieve bpdu or not.

MHM

 

After Ring is on, we have to check, but issue has been same 

then check show spanning tree VLAN 11 ROOT ID CHANGE 

VLAN0011
Spanning tree enabled protocol ieee
Root ID Priority 32779
Address 5ce1.76b0.1c00
This bridge is the root
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec

Bridge ID Priority 32779 (priority 32768 sys-id-ext 11)
Address 5ce1.76b0.1c00
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 15 sec

Interface Role Sts Cost Prio.Nbr Type
------------------- ---- --- --------- -------- --------------------------------
Gi1/0/1 Desg FWD 19 128.1 P2p
Gi1/0/2 Desg FWD 19 128.2 P2p
Gi1/0/3 Desg FWD 19 128.3 P2p
Gi1/0/5 Desg FWD 19 128.5 P2p
Gi1/0/6 Desg FWD 19 128.6 P2p
Gi1/0/9 Desg FWD 19 128.9 P2p
Gi1/0/10 Desg FWD 19 128.10 P2p
Gi1/0/12 Desg FWD 19 128.12 P2p
Gi1/0/25 Root FWD 4 128.25 P2p
Gi1/0/28 Desg FWD 4 128.28 P2p

Hello
Gi1/1 Desg FWD 4 128.1 P2p Peer(STP)
Gi1/2 Root FWD 4 128.2 P2p Peer(STP)
Fa1/2 Desg FWD 19 128.4 P2p
Fa1/3 Desg FWD 19 128.5 P2p
Fa1/4 Desg FWD 19 128.6 P2p

If the above is from your core switch, then its NOT the STP root for all the vlans (11) and its connected to a switch(s) that is not running  RSTP

Post the following from the core switch and its connected switches:
sh cdp neighbours
sh interface trunk

sh vlan brief
sh spanning-tree root
sh spanning-tree vlan 11



Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Thanks for support 

issue has been resolved 

How did u resolve it I am facing same issue?

Make new post it is better 

MHM

All switches letest  IOS update 

Fixing native vlan mismatches solved the issue for me

No thanks to me lol..

Glad issue is solved' the rstp is compatible with stp but in ring I will do more check why this happened.

Have a nice day 

MHM

hello MHM

mac flapping issue is resolved, but all switches ping is high latency 

Wait for at least 5hours then try ping.

Note that mac flapping stop but still mac not clear for some interface.

So wait until mac is aged and remove and then check

MHM

Hello..

Issue has been same please help me