MEM-XCEF720-256M

[mulugojjam abebe]

During the process of delivering  the cisco 6509-E switch to the customer, they asked me to show them the Catalyst 6500 256MB DDR, xCEF720 (67xx interface, DFC3A) memory, which is included by default, on the switch. i tried to see it on the sup engine, but i can't get it. So please help me on locating this memory module on the switch or command to verify that?

Thank you in advance

[Lei Tian]

Hi,

Here is the doc shows you where the memory physical located in the card.

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_12409.html

You can also use remote command module x show ver to check the memory size.

Regards,

Lei Tian

[mulugojjam abebe]

Thank you very much Lei Tian!!!