08-30-2020 05:29 AM
Hi Cisco Community,
I'm asked to migrate on of our switch. We will migrate from HP to Cisco.
Here is the HP Configuration (Access Switch) :
VLAN 1 : Default - VLAN 27 : Voice - VLAN 169 : Camera
Interface 25 is the link to the distribution switch
Access interfaces 0/1-0/3 & 0/5-0/24 are linked to users & phones (VLAN 1 & 27) and
Access interface 0/4 is linked to a camera (VLAN 169).
HP ProCurve Switch 2524# sh config IN-FLASH CONFIGURATION ; J4813A Configuration Editor; Created on release #F.01.08 time daylight-time-rule None hostname "HP ProCurve Switch 2524" ip timep dhcp snmp-server community "public" Unrestricted vlan 1 name "DEFAULT_VLAN" untagged 1-3,5-26 ip address dhcp-bootp exit vlan 169 name "VLAN169" untagged 4 tagged 1-3,5-26 exit vlan 27 name "VLAN27" tagged 1-26 exit
As I am more used to Cisco IOS than HP ones, I want to make sure I will be able to replicate the config quickly. I did this in PacketTracer. Should this configuration allow the Cisco switch to make the same work as the HP switch?
Switch(config)#vlan 27 Switch(config-vlan)#name Voice Switch(config-vlan)#vlan 169 Switch(config-vlan)#name Cameras Switch(config-vlan)#exit Switch(config)#int vlan 1 Switch(config-if)#ip address dhcp Switch(config-if)#exit Switch(config)#int range Ge0/1-3, Ge0/5-24 Switch(config-if-range)#switchport mode access Switch(config-if-range)#switchport access vlan 1 Switch(config-if-range)#switchport voice vlan 27 Switch(config-if-range)#exit Switch(config)#int Ge0/4 Switch(config-if)#switchport mode access Switch(config-if)#switchport access vlan 169 Switch(config-if)#exit Switch(config)#int Ge0/25
Switch(config-if)#switchport mode trunk
Switch(config-if)#switchport trunk native vlan 1
Thanks a lot for your feedback !
Best regards,
Nicolas Steinbusch.
Solved! Go to Solution.
08-30-2020 08:06 AM
Hello,
the converted configuration looks by the book. The only thing you need to add to the access (not the trunk) ports is:
spanning-tree portfast
08-30-2020 08:06 AM
Hello,
the converted configuration looks by the book. The only thing you need to add to the access (not the trunk) ports is:
spanning-tree portfast
09-02-2020 04:43 AM
@Georg Pauwen Thank you for your feed-back, it worked like a charm ! With that pre-configuration, it was about 15' on-site to unplug HP switch and plug the Cisco one !
09-02-2020 05:05 AM
Is that 15 seconds ? Faster than a Formula 1 pit stop ! Glad that the transition went smoothly...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide