01-10-2011 04:39 AM - edited 03-06-2019 02:54 PM
Hi,
i would like migrate a cat6513 with 2 supervisor sup720-3B to 1 sup720-10G.
Is it possible with no traffic interupt ?
best regards.
Pascal M.
01-10-2011 05:35 AM
Hello Pascal,
I'm afraid this is not possible as you can remove or change the standby supervisor but only with one of the same model
if you remove the standby supervisor and you install the sup720-10G it is likely that it will not be considered a match companion for the active supervisor and it will be stopped in rommon.
I know the redundancy code makes this check.
Hope to help
Giuseppe
01-10-2011 12:58 PM
I concur with Guiseppe. Even if you could get to RPR redundancy mode there is a 2-3 minute cutover time and even longer if you have DFC cards. And I am SURE you could not get to SSO mode.
01-14-2011 07:34 AM
Hi,
thanks a lot for your response.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide