MLS QOS on 2960S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-18-2015 08:45 AM - edited 03-07-2019 10:43 PM
Enabling MLS QOS on 2960S seems to "throttle" bandwidth when using a specific Mitel 5320 phone. I have a PC behind the Mitel and the performance is way slower. Validated via a speed test. Once I remove the MLS QOS globally, the performance is greatly improved, about doubled. This is causing some issues as users with this particular phone attached with a PC behind the phone are starting to complain. What could be causing this or what settings to overcome this?
- Labels:
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-18-2015 09:59 AM
What license you are using on 2960S switch ?
can you share the outputs of:
1. show version
2. show mls qos
3. show run int <int-id> --- where the mitel phone is connected to
4. show ip int br | ex unass
5. show int <int-id> --- where the phone is connected to
6. show mls qos int <int-id> statistics
This should help us to isolate the issue.
BR,
Ashwani
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-18-2015 11:24 AM
Attached are some of the outputs. What I am looking for is that one or two interface settings that will modify this behavior. If not, I will just remove the mls qos globally.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-18-2015 12:17 PM
1. You are not using Cisco IP phones, so remove the statement from the port config:
mls qos trust device cisco-phone
2. Try to disable DSCP rewrite option by:
conf t
no mls qos rewrite ip dscp
end
3. clear the counters and check if we are dropping packets. if yes, we need to tweak the QoS settings to get it working without any issues.
4. Once you clear the counters, please send the outputs after 10 minutes and after testing the scenario again:
a. show int <int-id>
b. show mls qos queue-set
c. show mls qos int <int-id> statistics
BR,
Ashwani
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-18-2015 10:02 AM
Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
Enabling QoS on a 2960/3560/3750, using defaults, often results in slow transfer performance. This because the default buffer settings often increase drop rates in the newly enabled egress queues. Manual buffer tuning might mitigate.
