Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Upgraded WLC 2504 from 7.6.120 to 7.6.130 and now I cannot log into the lobby ambassador portal. I use the same user id and password, then it says page cannot be displayed. I created another lobby ambassador account and I am getting the same...
Enabling MLS QOS on 2960S seems to "throttle" bandwidth when using a specific Mitel 5320 phone. I have a PC behind the Mitel and the performance is way slower. Validated via a speed test. Once I remove the MLS QOS globally, the performance is grea...
Helllo,I have a ACL applied on a WLAN on a 2125 controller. I cannot get the older Cisco IPSec (Version 5.0.05.0290) client to work through the ACL and through the WLAN onto it's destination. When the Cisco IPSec client is on another unrestri...
Hello,1231G AP boots fine in lab with power injector to several lab switches. AP then is sent to branch location with same type of power injector, not the one that was used in the lab though and when AP is powered up, 3 amber lights show up, port sh...
Here is the fix on this post...It works with a specific URL format... https://supportforums.cisco.com/discussion/12302816/url-fail-when-access-lobby-admin
Attached are some of the outputs. What I am looking for is that one or two interface settings that will modify this behavior. If not, I will just remove the mls qos globally.
Hello,AP is autonomous. This is the second AP and second power injector sent. 3560 port is set to auto/auto, switchport mode access, spanning tree portfast.
Hello,I have not heard of a rule of thumb on a particular number, but for 15 I would go with a controller. Easier to manage and support and create policies. There is a 2125 model that supports 25AP's. If you ever want to use the Cisco location app...
