Module 15 reset from Status Poll
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-10-2011
01:54 AM
- last edited on
03-25-2019
04:15 PM
by
ciscomoderator
Hi,
the CAT 6k5 (SUP2-2GE) periodic reload MSFC2 without User activity, following message appears in CAT logging buffer:
-Module 15 reset from Status Poll//
CAT 6k5 runs with CatOS - 8.2(2), MSFC2 with IOS - 12.1(20)E.
CAT 6k5 CPU load - 2%
MSFC2 CPU load - 4%
sh test all (Diagnostic mode complete) - ALL OK.
Any Ideas what the reason is?
Best regards
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-15-2011 08:03 AM
Hi,
The error indicates that the supervisor module reset the routing module (MSFC) due to loss of a keepalive packets that flows between the sup and MSFC. Possible causes are the cpu was to busy on the MSFC to process the keeaplive, the traffic was dropped on the channel between the two components.
In order to rule out a hw issue, we can reset the modules with diagnostics set to the complete. This will also reprogramall the hardware asics which may help.
- set diagnosic level complete
- Reset the supervisor.
When the sup is back up.
- sh test
Hope this helps,
Shashank
