03-07-2019 08:05 AM
I have a pair of Cisco 2960 switches (Stacked) in a VOIP environment. Trying to record the voice traffic.
The current set up is:
monitor session 2 source interface Gi1/0/21 - 22
monitor session 2 source interface Gi2/0/21 - 22
monitor session 2 destination interface Gi1/0/24
monitor session 2 destination interface Gi1/0/24
If this is correct;
Will the traffic that is sent to Gi1/0/24 be identical to the traffic sent to Gi2/0/24
Will all the traffic from both "sources" be sent to both "destinations?
Thanks,
Brian
03-07-2019 08:31 AM - edited 03-07-2019 08:34 AM
Hello,
monitor session 2 source interface Gi1/0/21 - 22
monitor session 2 source interface Gi2/0/21 - 22
monitor session 2 destination interface Gi1/0/24
monitor session 2 destination interface Gi1/0/24
If this is correct;
Will the traffic that is sent to Gi1/0/24 be identical to the traffic sent to Gi2/0/24
Will all the traffic from both "sources" be sent to both "destinations? < on this case all traffic will be sent to G1/0/24
you have just one destination to session monitor 2.
Check it for more information: http://www.cisco.com/en/US/customer/docs/switches/lan/catalyst2960/software/release/12.2_55_se/configuration/guide/swspan.html#wp1036829
Regards.
03-07-2019 02:25 PM
adding to other post :
if all the interface range in one Access VLAN then monitor the VLAN interface is good idea i guess.
also make sure monitor destination interface from access VLAN.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide