Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is the following even possible? I would like to configure Microsoft NPS to act as a Radius Server to authenticate and allow users who are present in one of two active directory OU's (OU #1 & OU I#2) to ssh into the device and then if the user is in O...
I have a bunch of C9200 and C9300 switches. Call-Home profile is configured with "destination transport-method http". A Google search seems to indicate I should be able to change that to "destination transport-method https" but when I try to I get a ...
The old Speechview worked with Unity Interview Handlers to capture the entire interview. With the new Webex Speehview for Unity, the transcription only captures the first .wav file of the messageid, rather than all of them.Support is suggesting that ...
We have a Firepower1120 ver 7.2.5.1, in a production environment. The device is managed by FMC.We have purchased a Firepower1150 so we can utilize the 10 GIG interfaces.I am looking for the best way to duplicate (as closely as possible) as much as po...
We have a Firepower 1120 running ver. 7.2 software and managed by FMC.We have two ISP public IP addresses. We are attempting to configure a "Server Failover" address on the same firewall so if ISP 1 goes down that we can connect the VPN via ISP 2 add...
We are accessing Cisco C9200, C9300 and C1000 switches. Our Domain Controller server is Windows Server 2019.I have this working (mostly) with the exception that read only users cannot do a "Show Run". Here is my (sanitized) config :B007-SW21#sh run...
Does anyone have more detailed info on this? We have a failover IP with a second ISP working for internet traffic working. We have created a profile with the Primary and Secondary connections, however when we are in a failover situation the AnyConnec...
I am hitting the wall here. The way I have this configured now, I can get 1750 - 1850 MB upload (clearly the LACP is working) BUT I can only get 950 GB download. If I remove the "globally added load-balance" command, my upload also drops to less than...
This is a FirePower 1120 and as far as I can tell it has 12 Gig capable interfaces. The reading I have done it seems like they interchange "Port Channel" and "EtherChannel" ."When you bind multiple physical ports together an interface which is create...
