08-10-2022 12:58 PM
Hi,
Setup:
FW -> Dummy Switch -> 3 clients (GW is the FW port)
I have a managed switch where ive configured 3 ports as access and vlan x untagged. I want to remove the dummy switch and put these 3 clients on the managed one.
My mind is totally blank at the moment, cant think of what im doing wrong hence the question
As the 3 ports are access mode, same vlan and untagged, shouldnt it then act as the same way as a dummy switch?
08-10-2022 01:01 PM
Fixed it, the ports was in protected state ^^
08-11-2022 01:02 AM
Hello
@S3C wrote:FW -> Dummy Switch -> 3 clients (GW is the FW port)As the 3 ports are access mode, same vlan and untagged, shouldnt it then act as the same way as a dummy switch?
Just plug them in the manage switch and that should work straight away, however you can make a little change to the ports.
switch
int x/x
switchport mode access
spanning-tree portfast
no shut
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide