MPLS Configuration. Am i setup correctly ?

[Thomas Leong]

am i setup correctly ? i tot it will follow by the label to go ? or because it followed by OSPF shortest path ?

[Kasun Bandara · Accepted solution]

Hi,

normally packet path is selected according to routing algorithm such as OSPF or BGP (as you configured OSPF). underlayer transport method is not a an issue to that such as MPLS, LTE, etc.

mark as answer, if this solved your concern

[Thomas Leong]

@Kasun Bandara 

1. Unless i change the ospf cost right haha hmmmm. anyway thanks ya ~

2. one more question, does pop label means remove MPLS header ?

[Kasun Bandara]

2. yes you are correct

[Harold Ritter]

Hi @Thomas Leong ,

> 2. one more question, does pop label means remove MPLS header ?

It depends. Popping a label will cause the MPLS header removal in the case there is only one label in the stack, but if there is more than one label, the top label is removed without removing the MPLS header.

Regards,