Hi ,
I am seeing MPLS TE Tunnel is not coming up in my setup.
I am using XRV node running version 7.11.2. I have explained below the config and status.
Could anyone please check and comment on this issue ?
XRV-A Config:
RP/0/RP0/CPU0: XRv-A#show running-config interface tunnel-te 7
Wed May 8 07:34:55.889 UTC
interface tunnel-te7
description RSVPtunnel
ipv4 unnumbered Loopback0
signalled-name XRV-A
autoroute announce
!
destination 92.168.96.24
path-option 1 dynamic
!
RP/0/RP0/CPU0:XRv-A#show running-config router ospf 1
Wed May 8 06:19:12.705 UTC
router ospf 1
router-id 92.168.96.26
redistribute connected
area 0.0.0.0
mpls traffic-eng
interface GigabitEthernet0/0/0/2.10
network point-to-point
!
mpls traffic-eng router-id Loopback0
!
RP/0/RP0/CPU0:XRv-A#show running-config rsvp
Wed May 8 06:19:36.765 UTC
rsvp
interface GigabitEthernet0/0/0/2.10
!
!
RP/0/RP0/CPU0:XRv-A#show running-config mpls traffic-eng
Wed May 8 06:19:42.471 UTC
mpls traffic-eng
interface GigabitEthernet0/0/0/2.10
!
RP/0/RP0/CPU0: :XRv-A#show running-config interface loopback 0
Wed May 8 06:32:08.518 UTC
interface Loopback0
ipv4 address 92.168.96.26 255.255.255.255
!!
RP/0/RP0/CPU0:XRv-A#show running-config interface GigabitEthernet0/0/0/2.10
Wed May 8 07:43:16.876 UTC
interface GigabitEthernet0/0/0/2.10
ipv4 address 10.10.15.1 255.255.255.252
encapsulation dot1q 10
!
RP/0/RP0/CPU0: XRv-A#show ospf neighbor
Wed May 8 06:53:28.103 UTC
* Indicates MADJ interface
# Indicates Neighbor awaiting BFD session up
Neighbors for OSPF 1
Neighbor ID Pri State Dead Time Address Interface
92.168.96.24 1 FULL/ - 00:00:37 10.10.15.2 GigabitEthernet0/0/0/2.10
Neighbor is up for 00:26:29
RP/0/RP0/CPU0:XRv-A#show mpls traffic-eng tunnels 7
Wed May 8 07:44:29.749 UTC
Name: tunnel-te7 Destination: 92.168.96.24 Ifhandle:0x1c
Signalled-Name: XRV-A
Status:
Admin: up Oper: down Path: valid Signalling: RSVP signaling proceeding
path option 1, type dynamic
G-PID: 0x0800 (derived from egress interface properties)
Bandwidth Requested: 0 kbps CT0
Creation Time: Tue May 7 06:28:17 2024 (1d01h ago)
Config Parameters:
Bandwidth: 0 kbps (CT0) Priority: 7 7 Affinity: 0x0/0xffff
Metric Type: TE (global)
Path Selection:
Tiebreaker: Min-fill (default)
Hop-limit: disabled
Cost-limit: disabled
Delay-limit: disabled
Delay-measurement: disabled
Path-invalidation timeout: 10000 msec (default), Action: Tear (default)
AutoRoute: enabled LockDown: disabled Policy class: not set
Forward class: 0 (not enabled)
Forwarding-Adjacency: disabled
Autoroute Destinations: 0
Loadshare: 0 equal loadshares
Load-interval: 300 seconds
Auto-bw: disabled
Auto-Capacity: Disabled:
Self-ping: Disabled
Fast Reroute: Disabled, Protection Desired: None
Path Protection: Not Enabled
BFD Fast Detection: Disabled
Reoptimization after affinity failure: Enabled
Soft Preemption: Disabled
History:
Current LSP:
Setup Time: 57 seconds
Reopt. LSP:
Last Failure:
Re-opt LSP signalling time-out
Date/Time: Tue May 07 10:54:59 UTC 2024 [20:49:30 ago]
First Destination Failed: 92.168.96.24
Prior LSP:
ID: 298 Path Option: 1
Removal Trigger: setup timed out
Path info (OSPF 1 area 0.0.0.0):
Node hop count: 1
Hop0: 10.10.15.2
Hop1: 92.168.96.24
LSP Tunnel 92.168.96.24 7 [301] is signalled, Signaling State: up
Tunnel Name: XRV-B Tunnel Role: Tail
InLabel: GigabitEthernet0/0/0/2.10, implicit-null
Signalling Info:
Src 92.168.96.24 Dst 92.168.96.26, Tun ID 7, Tun Inst 301, Ext ID 92.168.96.24
Router-IDs: upstream 92.168.96.24
local 92.168.96.26
Bandwidth: 0 kbps (CT0) Priority: 7 7 DSTE-class: 0
Soft Preemption: None
SRLGs: not collected
Path Info:
Incoming Address: 10.10.15.1
Incoming:
Explicit Route:
Strict, 10.10.15.1
Strict, 92.168.96.26
Record Route: Disabled
Tspec: avg rate=0 kbits, burst=1000 bytes, peak rate=0 kbits
Session Attributes: Local Prot: Not Set, Node Prot: Not Set, BW Prot: Not Set
Soft Preemption Desired: Not Set
Resv Info: None
Record Route: Disabled
Fspec: avg rate=0 kbits, burst=1000 bytes, peak rate=0 kbits
Displayed 1 (of 1) heads, 0 (of 0) midpoints, 1 (of 1) tails
Displayed 0 up, 1 down, 0 recovering, 0 recovered heads
RP/0/RP0/CPU0:XRv-A#show interfaces tunnel-te 7
Wed May 8 08:05:36.859 UTC
tunnel-te7 is down, line protocol is down
Interface state transitions: 4
Hardware is Tunnel-TE
Description: RSVPtunnel
XRV-B config:
RP/0/RP0/CPU0:XRv-B#show running-config interface gigabitEthernet 0/0/0/2.10
Wed May 8 07:58:54.490 UTC
interface GigabitEthernet0/0/0/2.10
ipv4 address 10.10.15.2 255.255.255.252
encapsulation dot1q 10
!
RP/0/RP0/CPU0:XRv-B#show running-config interface loopback 0
Wed May 8 07:59:33.424 UTC
interface Loopback0
ipv4 address 92.168.96.24 255.255.255.255
!
RP/0/RP0/CPU0:XRv-B#show ospf neighbor
Wed May 8 07:59:52.277 UTC
* Indicates MADJ interface
# Indicates Neighbor awaiting BFD session up
Neighbors for OSPF 1
Neighbor ID Pri State Dead Time Address Interface
92.168.96.26 1 FULL/ - 00:00:37 10.10.15.1 GigabitEthernet0/0/0/2.10
Neighbor is up for 2w0d
Total neighbor count: 1
RP/0/RP0/CPU0:XRv-B#show running-config router ospf 1
Wed May 8 08:00:16.799 UTC
router ospf 1
router-id 92.168.96.24
redistribute connected
address-family ipv4 unicast
area 0.0.0.0
mpls traffic-eng
interface Loopback0
!
interface GigabitEthernet0/0/0/2.10
network point-to-point
!
!
mpls traffic-eng router-id Loopback0
!
RP/0/RP0/CPU0:XRv-B#show running-config rsvp
Wed May 8 08:00:49.427 UTC
\rsvp
interface GigabitEthernet0/0/0/2.10
!
!
RP/0/RP0/CPU0:XRv-B#show running-config mpls traffic-eng
Wed May 8 08:00:54.751 UTC
mpls traffic-eng
interface GigabitEthernet0/0/0/2.10
!
!
RP/0/RP0/CPU0:XRv-B#show mpls traffic-eng tunnels 7
Wed May 8 08:02:52.520 UTC
Name: tunnel-te7 Destination: 92.168.96.26 Ifhandle:0x1c
Signalled-Name: XRV-B
Status:
Admin: up Oper: down Path: valid Signalling: RSVP signaling proceeding
path option 1, type dynamic
G-PID: 0x0800 (derived from egress interface properties)
Bandwidth Requested: 0 kbps CT0
Creation Time: Tue May 7 09:37:58 2024 (22:24:54 ago)
Config Parameters:
Bandwidth: 0 kbps (CT0) Priority: 7 7 Affinity: 0x0/0xffff
Metric Type: TE (global)
Path Selection:
Tiebreaker: Min-fill (default)
Hop-limit: disabled
Cost-limit: disabled
Delay-limit: disabled
Delay-measurement: disabled
Path-invalidation timeout: 10000 msec (default), Action: Tear (default)
AutoRoute: enabled LockDown: disabled Policy class: not set
Forward class: 0 (not enabled)
Forwarding-Adjacency: disabled
Autoroute Destinations: 0
Loadshare: 0 equal loadshares
Load-interval: 300 seconds
Auto-bw: disabled
Auto-Capacity: Disabled:
Self-ping: Disabled
Fast Reroute: Disabled, Protection Desired: None
Path Protection: Not Enabled
BFD Fast Detection: Disabled
Reoptimization after affinity failure: Enabled
Soft Preemption: Disabled
History:
Current LSP:
Setup Time: 49 seconds
Prior LSP:
ID: 304 Path Option: 1
Removal Trigger: setup timed out
Path info (OSPF 1 area 0.0.0.0):
Node hop count: 1
Hop0: 10.10.15.1
Hop1: 92.168.96.26
LSP Tunnel 92.168.96.26 7 [303] is signalled, Signaling State: up
Tunnel Name: XRV-A Tunnel Role: Tail
InLabel: GigabitEthernet0/0/0/2.10, implicit-null
Signalling Info:
Src 92.168.96.26 Dst 92.168.96.24, Tun ID 7, Tun Inst 303, Ext ID 92.168.96.26
Router-IDs: upstream 92.168.96.26
local 92.168.96.24
Bandwidth: 0 kbps (CT0) Priority: 7 7 DSTE-class: 0
Soft Preemption: None
SRLGs: not collected
Path Info:
Incoming Address: 10.10.15.2
Incoming:
Explicit Route:
Strict, 10.10.15.2
Strict, 92.168.96.24
Record Route: Disabled
Tspec: avg rate=0 kbits, burst=1000 bytes, peak rate=0 kbits
Session Attributes: Local Prot: Not Set, Node Prot: Not Set, BW Prot: Not Set
Soft Preemption Desired: Not Set
Resv Info: None
Record Route: Disabled
Fspec: avg rate=0 kbits, burst=1000 bytes, peak rate=0 kbits
Displayed 1 (of 1) heads, 0 (of 0) midpoints, 1 (of 1) tails
Displayed 0 up, 1 down, 0 recovering, 0 recovered heads
RP/0/RP0/CPU0:XRv-B#show running-config interface tunnel-te 7
Wed May 8 08:02:59.789 UTC
interface tunnel-te7
description RSVPtunneltoA
ipv4 unnumbered Loopback0
signalled-name XRV-B
autoroute announce
!
destination 92.168.96.26
path-option 1 dynamic
!
RP/0/RP0/CPU0:XRv-B#show interfaces tunnel-te 7
Wed May 8 08:06:11.917 UTC
tunnel-te7 is down, line protocol is down
Interface state transitions: 0
Hardware is Tunnel-TE
