MS425 Physical Stacking

[AGUILLEMRO]

Hi everyone,

I have Two MS425 for physical stacking, Can I create multiple uplinks then Aggregate ports downlink to a 3 separate MS350?

Hope you can provide me understanding if this is possible.

Thank you 🙂

[AjitKumar · Accepted solution]

Hi @AGUILLEMRO,

I understand the below should be possible.

You need to choose the desired ports and enable Aggregation service.

[AGUILLEMRO]

Thank you @AjitKumar

[Eric Boers]

Hi,

I have also a question about stack a Meraki 425.
At the moment we have 2x meraki 425 seperately as distribution switches but not in stack. I want to make this network redundant without blocked STP by stacking these 2 switch into 1 stack.
Unfortunately is the 425 model a little bit special and does not have a hardcoded stackport but a flexible interface you need to config to become a stack.
I don't have any spares to test and my questions is: does anyone know if stack settings remain hardcoded for MS425 after the stack config push, without first having to retrieve the config from the cloud?
The intention is for CS1 to remain active, and CS2 will be added to it, forming a single stack, provided the stack config on CS2 remains hardcoded and doesn't require an uplink first.

Thanks in advance.