multi layer switch - cisco packet tracer
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2017 10:30 AM - edited 03-08-2019 09:29 AM
I am not able to ping any switch from router 3. How do i set up default-gateway for this switch ( not the default-network)
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2017 11:02 AM
Are you using this switch as a Layer 2 or Layer 3 device? do you have routes and SVIs configured in your switches?
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2017 12:25 PM
layer 2.
but the issues is solved.i had given "no ip routing" command previously.
Thanks for your help though.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2017 11:23 AM
Hi
Could you please share your configuration?, are you using any routing protocol? The default-gateway can be configured using: ip default-gateway <Gateway IP of your management Vlan>, it is useful to enable the access for remote access through vty lines.
>> Marcar como útil o contestado, si la respuesta resolvió la duda, esto ayuda a futuras consultas de otros miembros de la comunidad. <<
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2017 12:24 PM
Yes, I am using OSPF.
The issues is solved, I realized that I have disabled the routing by "no ip routing" command ( was following the tutorial :p).
But thanks for help though.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2017 12:25 PM
Hi,
Good to know
Have a great day
:-)
>> Marcar como útil o contestado, si la respuesta resolvió la duda, esto ayuda a futuras consultas de otros miembros de la comunidad. <<
