- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-21-2010 06:49 PM - edited 03-06-2019 12:08 PM
Hi !
I would like to know if we have more then one router is annoncing it self as an rp-candidate for the same group of multicast group which one will be choosen by receiver ? is the router to which receiver as the lower cost too ? the source to which have the lower cost to ? higher or lower router IP address within it's annoncement ?
what is the selection process exactly !
thanks a lot !
Solved! Go to Solution.
- Labels:
-
Other Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-21-2010 07:57 PM
Hi,
If multiple ip pim rp-address commands are configured, the following rules apply:
•Highest RP IP address selected regardless of reachability: If a multicast group is matched by the access list of more than one configured ip pim rp-address command, then the RP for the group is determined by the RP with the highest RP address configured.
HTH
Reza
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-21-2010 07:57 PM
Hi,
If multiple ip pim rp-address commands are configured, the following rules apply:
•Highest RP IP address selected regardless of reachability: If a multicast group is matched by the access list of more than one configured ip pim rp-address command, then the RP for the group is determined by the RP with the highest RP address configured.
HTH
Reza
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-22-2010 04:23 AM
As Riza mentioned, the RP with the highest IP address is elected as an RP candidiate for that Group.
Mohamed
