You can configure a single RP for more than one group using an access list. If no access list is specified, the static RP will map to all multicast groups, 224/4.
You can configure multiple RPs, but only one RP per group range.
If multiple ip pim rp-address commands are configured, the following rules apply:
Highest RP IP address selected regardless of reachability: If a multicast group is matched by the access list of more than one configured ip pim rp-address command, then the RP for the group is determined by the RP with the highest RP address configured.
Help us make the Cisco smart building solutions more useful for your industry.
Let us know how important these solutions are to your company by answering this short 4-question survey (your responses will remain completely anonymous).
Please take a minute...
Introduction to Routing ProtocolsStatic vs DynamicDistance Vector vs Link StateRoute Selection AlgorithmSingle Routing Protocol OnlyOpen Shortest Path First (OSPF)AreasRoute ConvergencePath SelectionMetric CalculationCharacteristicsEnhanced Interior Gatew...
Cisco DNA Center version 2.2.2.x includes the features and improvements that
New intelligence provides an easy, gradual, and complete adoption of SD-Access. Faster Cisco DNA Center set-up saves time and effort.
When using Cisco cellular modules with a SIM card an APN must be provided. The APN cannot be stored in the SIM card and is supplied by your SIM card provider. Cisco cellular software contains a database of well-known APNs based on the country and ...
Cisco 3850: IOS-XE/Firmware Upgrade
This procedure is aimed at Cisco 3850 switch ONLY.
IOS-XE Bundle Mode is not covered.
9300, 9500 (vanilla & high-performance), ISR 1k, ISR 4k and ASR is not covered.