Hi,
Can you help me to provide information where i can find the BOM (Bill of Materials) for the switch with following specs ?
• Two core switches are required for redundancy on the architecture level.
• Every switch shall be fully redundant in power supplies and supervisor engines.
e Core switches are used to build a collapsed core layer which is responsible for routing
functions, aggregating 10 Gig uplinks from access layer and hosting servers.
10 GE ports shall be equipped with original X2 interfaces from same manufacturer of the
core switches.
• Each of the two core switches should meet the following minimum specs:
o Rack mount Modular chassis with a minimum of 1 free slot after installing all modular
components.
o Must have passive backplane architecture.
o Must be configured with redundant power supplies.
o Must be configured with a supervisory or control module and minimum 512MB RAM
expandable to 1GB.
o Must have a minimum redundant switching capacity of 720Gbps.
o The supervisory module must have at least two 10 Gigabit Ethernet ports equipped
with two SR X2 modules.
o Must be configured with (1) one 4-port 10Gigabit Ethernet modules fully populated
with the correct type of XENPAK's (X2). XENPAK's (X2) must be provided by the same
manufacturer providing the switches for compatibility and optimum performance.
o One 48 10/100/1000 ports fabric enabled module must be installed with DFC card for
servers connectivity
o One 48 Gig SFP ports module must be installed and equipped with the required SFPs.
o One 48 10/100/1000 ports fabric enabled module to connect Call Center agent
workstations and IP Phones.
Thanks in Anticipation
Hi,
Check out the below product items for the above requirement
WS-C6513-FWM-K9 Cisco Catalyst 6513 Firewall Security System
S733ESK9-12218SXF Cisco CAT6000-SUP720 IOS ENTERPRISE SERVICES SSH
CF-ADAPTER-SP SP adapter for SUP720 and SUP720-10G
MEM-SUP720-SP-1GB Catalyst 6500 1GB SP memory for Sup720 and Sup720-3B
MEM-MSFC3-1GB 1GB Mem for Sup720, Sup720-3B and MSFC2A
WS-SUP720-3B Catalyst 6500/Cisco 7600 Supervisor 720 Fabric MSFC3 PFC3B
CF-ADAPTER-SP SP adapter for SUP720 and SUP720-10G
MEM-SUP720-SP-1GB Catalyst 6500 1GB SP memory for Sup720 and Sup720-3B
MEM-MSFC3-1GB 1GB Mem for Sup720, Sup720-3B and MSFC2A
WS-X6748-SFP Catalyst 6500 48-port GigE Mod: fabric-enabled (Req. SFPs)
GLC-SX-MM GE SFP, LC connector SX transceiver
WS-X6748-GE-TX Cat6500 48-port 10/100/1000 GE Mod: fabric enabled, RJ-45
WS-CAC-6000W Cat6500 6000W AC Power Supply
CAB-AC-2500W-EU Power Cord, 250Vac 16A, Europe
MEM-C6K-CPTFL512M Catalyst 6500 Sup720/Sup32 Compact Flash Mem 512MB
BF-S720-64MB-RP Bootflash for SUP720-64MB-RP
Just cross check the line items with your requirement most of them should cover.
Hope to help !!
Ganesh.H
If helpful do rate the post
