Hi all I'm setting up a CISCO LAB to keep me busy in my retirement. My Current network consists of a TP-Link Deco mesh network which works well for my IOT, PCs and internet access. I just got hold of a Cisco 1941 router with a EHWIC D8SGP module. My Plan was to put my Lab behind the 1941 with a gateway to the internet via the Deco main unit and have 3 VLANs and routing configured to allow inter VLAN routing and internet access.
From the console I can resolve hostnames and ping servers on the internet. But can't ping any of the VLAN interfaces.
The gigabitethernet0/0 interface gets allocated a reserved IP address from the Deco (192.168.68.99 255.255.252.0)
I don't get any DHCP leases except from the 10.0.1.0 network (native VLAN1).
I'm pulling my hair out as 20 years ago I used to configure this **bleep** as a job. Getting old and the memory is not so great these days. One of the reasons I am setting up the lab to keep my mind active.
Any help would be appreciated. I've attached a copy of my current config and a file with show IP routes, version and vlans. Let me know if any further info is needed. Hopefully its a simple fix I just can't see.
Colin
