Need some help with: CISCO Commands 960 Plus SI Poe

[hmiltenburg]

Find attached the questions

For some reason it is blocked when I put it here and marked as spam.

[mvsheik123]

Hello,

Did you try issuing the 'auto qos voip trust' in interface configuration mode   : switch (config-if)#?

If that does not work, pls post exact model and software version of old and new switches?

Thx

MS

[hmiltenburg]

Hi,

First of all thanks for your answer,

• We have a Cisco 2960 48 Prt SI PoE switch, this is the new version. Version of software is: v.15
• Our previous Cisco 2960 48Prt PoE sitch, is the older version. Version of software is: v12.2

Wen I configure the Interfaces in config-if , all goes well except the 'auto qos voip trust' entry.

1. Is this command still needed with version 15 of Cisco?

The entries about qos are in the beginning of our template and set like: see attached.

1. Are these commands still needed with version 15 of Cisco?

Regards

[mvsheik123]

Hi,

Based on the below link, the command is available.

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/15-0_2_ez/command/reference/cr2960/cli1.html

Try removing any QOS config and add again.

hth

MS