02-07-2012 01:29 AM - edited 03-07-2019 04:46 AM
Hi
I am trying to use the following commands on the switch but it is not supported:
ip route-cache flow
ip flow-export destination
Attached is the output for show version and show module commands from the switch.
I will appreciate support from the cisco community to help me get this fixed.
Thanks
Ibrahim Sayeed
02-07-2012 02:07 AM
Is it mandatory to have a NetFlow Service Card installed in the switch to use netflow commands.
02-07-2012 04:40 AM
Hello Ibrahim,
This feature is only supported if you have a netflow services card (WS-F4531). Without this, it won't support. Below is a link which provides this info
&
http://www.solarwinds.com/documentation/Netflow/docs/OrionNetFlowSwitches.pdf
Thanks
Vivek
02-07-2012 05:37 AM
Hi Ibrahim,
All 4500 series switches need a seperate NetFlow service card to be configured to support NetFlow.
For your information, I have a 4507R for one of my customer without this card and unable to configure NetFlow.
So then I suggested to my customer to buy a seperate card to be work NetFlow on this switch. Once I instaleed the card and then only I was able to configure the NetFlow.
Hope the above clear and understand you.
Please rate all the helpfull posts.
Regards,
Naidu.
02-07-2012 05:47 AM
Thanks Guys. Appreciate ur support. So now once I get this service card installed I shud b able to configure the netflow commands.
02-07-2012 05:53 AM
Yes you are right. All the netflow based commands will be auto-enabled as soon as you install the service card.
Please close the thread if we have answered your query.
Thanks
Vivek
02-07-2012 06:03 AM
Hi Ibrahim,
Once you inserted the card in slot (host swapable), once the IOS detected the card and sync done, you will be able to find all realted commands.
Hope the above clear and understand you.
Please rate all the helpfull posts.
Regards,
Naidu.
02-07-2012 09:24 PM
Thanks a lot guys for your support.
R
Ibrahim SAYEED
04-16-2012 04:39 AM
Hey Guys
Check out this link
Does this mean we can configure the Flexible NetFlow commands without netflow services card (WS-F4531)?
04-16-2012 10:22 PM
Hi
Check this discussion. Hope it helps anyone looking for a similar answer or going thru same confusion.
https://supportforums.cisco.com/message/3613222#3613222
R
Ibrahim SAYEED
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide