Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWill appreciate if you can guide me here:1. 9951 phones working fine with firmaware sip9951.9-0-1SR12. Added a new 9951 phone but it does not register as the firmware it is using is sip9951.9-2-2SR1-9From: <sip:2823@172.29.27.250>;tag=c40acbe137ec0...
HiOne of my client uses CUCM V5.1.3 and now needs SRST to be deployed for them. Are there any limitations related to compatibility between CUCM v5.1.3 and SRST ver 9.x.Appreciate the replies.Thanks Ibrahim Sayeed
HiI will appreciate support for a situation I have encountered for one customer.The server hardware is MCS 7825. A total of upto 600 IP phones registered. I noticed that the conference bridge is registered on the subsriber.Client have 1 Publisher & 1...
HiI am trying to configure RSPAN for one of my client. They have Server-Client VTP architecture.Voice Recording Server is connected to C4507.Agents are connected to C2960 and C3750.I got 2 sessions configured and the connectivity is a as follows:1. V...
HiSite A- CUCME + CUESite B - CUCMECUE from Site A to be pulled out and used at Site B. I have already installed the ISM module at Site B and i can access it but it not able to communicate with CUCME to fetch phones information as it was previosuly c...
Thanks all for sharing your knowledge on this topic.Our cisco account manager also gave us a very nice document to read which clarified further for me to proceed with finalizing our solution. http://www.cisco.com/en/US/docs/voice_ip_comm/cusrst/requ...
Hi AmanThnx for a quick reply. After reading the following posts I understood that SRST does not depend on Call manager version but would give problems with phone loads in case the SRST version was lower than the CUCM version. In my case the cucm ve...
